Whether it is measured by mcl, ml or cc, each time the actuator is pressed, the fine mist sprayer and the lotion pump have a specific output. The output of a lotion pump is usually much higher than that of a sprayer, because the pump has a larger pump engine to dispense more products, and it is designed for higher output requirements, such as body lotion, shampoo, hand soap, dishwashing Soap etc. Dispensed usually have a higher viscosity, such as soap and cream.
For fine mist sprayers, liquid or low-viscosity oils are "atomized" in the sprayer engine and sprayed in a wide range and controllable manner. These sprayers are designed to provide wide coverage when dispensing products. The product becomes a very fine mist, so it is called atomization and is sprayed in a broad but predictable way.
The process of cutting the tube
We know that everyone’s application is different, so each of you may have a unique dip tube length for your particular bottle. In order to fully meet your needs, we have proposed a simple, step-by-step process that will provide you with a suitable fine mist sprayer with the correct immersion tube length required.
It all starts with you: just click on the "Required custom dip tube length" checkbox on the product page, change the required quantity to the required quantity, and click "Add to Cart". The process of placing an order at checkout
Our turn: We will process your order and contact you to determine your dip tube length requirements
If you already know the length of the dip tube, then: just email your dip tube length requirement (in millimeters) back. If you want to measure your own dip tube length, please refer to this packaging crash course article to learn how we do the measurement, so we are on the same page
If you do not know the length of the dip tube, you need: we can tailor it for you! Just mail us the bottle that the sprayer will enter, and we will determine the correct dip tube length for you
Your turn: No matter which measurement method is used, we will send you a sample of the sprayer, cut the dip tube to the specified length, and attach the approval form. Please check and test whether the sprayer is installed correctly, and return the signed approval form to us as soon as possible digitally or by mail. This step ensures that the sprayer you want fits the bottle you want to put in
Our turn: After your approval, we will cut the remaining sprayers and ship your order when ready
From the receipt of the approval letter to the time we ship your order, please allow 1-2 weeks for the immersion tube cutting time.
Whether measuring the dip tube length by us or by your means, the dip tube sample approval process is critical. Since we signed and received the approval form, we will not deviate from this length. Therefore, it is very important to test and fit samples.